Those holes were for an "emergency" spike suppression capacitor if I found
it needed one in that part of the circuit. It ran fine without it, so you
can leave it out. The cap would have been around 10 to 20 pF if it had been
used.
Ken
Ken Stone sasami@...
Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>
it needed one in that part of the circuit. It ran fine without it, so you
can leave it out. The cap would have been around 10 to 20 pF if it had been
used.
Ken
>Hey Ken -_______________________________________________________________________
>
>There's a spot for a component along the bottom edge of the VC
>divider board.. below the LM358. Looks to be the right size for a .01
>cap, but it's unlabeled and does not show on the schematic.
>
>What are those holes for?
>
>
>
>
>
>See the following URLS for the CGS Modular Synth home page:
>http://198.164.142.50/~cgs/
>http://shokbox.obscure.ca/~cgs/
>
>To unsubscribe from this group, send an email to:
>cgs_synth-unsubscribe@yahoogroups.com
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
Ken Stone sasami@...
Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>