aloha folks!
i thought about using smaller knobs for this unit - but i'd rather it stay in the format
of things motm and not take up too much space (running out of cab space). but yeah
the UEG layout could work. on the panel i made up i left out the MIX IN jack - as usefull
it might be i felt it was the least of the things i would want in a mini seq/audio channel switcher.
i think your right about the up/down jack - im not sure about the RSS
also - has anyone in here experimented w/ a gated sequencer panel that is 2U or at least 3u?
i'm running very short on space - but an 8 stag gate seq would be handy - the panels i've seen
you guys make are all 4u or 5u - on those panels do the switch holes match up to the switch
board PCB from ken? i'm thinking of some cutting n pasting ;)
all the best folks
dave wright
(who says thumbs up to the saw shifter/waveshaper)
i thought about using smaller knobs for this unit - but i'd rather it stay in the format
of things motm and not take up too much space (running out of cab space). but yeah
the UEG layout could work. on the panel i made up i left out the MIX IN jack - as usefull
it might be i felt it was the least of the things i would want in a mini seq/audio channel switcher.
i think your right about the up/down jack - im not sure about the RSS
also - has anyone in here experimented w/ a gated sequencer panel that is 2U or at least 3u?
i'm running very short on space - but an 8 stag gate seq would be handy - the panels i've seen
you guys make are all 4u or 5u - on those panels do the switch holes match up to the switch
board PCB from ken? i'm thinking of some cutting n pasting ;)
all the best folks
dave wright
(who says thumbs up to the saw shifter/waveshaper)
----- Original Message -----
From: elle_webb
To: cgs_synth@yahoogroups.com
Sent: Friday, June 13, 2003 6:28 AM
Subject: [cgs_synth] Re: New file uploaded to cgs_synth
--- In cgs_synth@yahoogroups.com, cgs_synth@yahoogroups.com wrote:
> Description : a draft for a motmized sequential switch panel -
comments welcome (leds are not lined up yet right)
This looks good overall.
The only thing I'm not sure about is whether it would make sense to
somehow line up the stage knobs with the stage in's, gates & led's.
That's what they did with the UEG, which is similar in some ways:
http://www.encoreelectronics.com/cont_ueg1.html
To get everything lined up and still keep the pots with MOTM spacing
would eat up a lot of panel space, though.
I have a question - how does the Up/down jack wire in? This is how
I'm reading it:
UD switch - Top to +15, middle to SW pad, bottom to NC connector or
UD jack.
UD jack then would have the signal connector wired to UD pad.
Is that right?
Also - what the RSS pad on the pcb for?
Thanks!
Yahoo! Groups Sponsor
See the following URLS for the CGS Modular Synth home page:
Main: http://www.cgs.synth.net/
Secondary: http://otherunicorn.0catch.com/synth/
To unsubscribe from this group, send an email to:
cgs_synth-unsubscribe@yahoogroups.com
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
[Non-text portions of this message have been removed]