hello all,
well I have just completed the cv cluster module and it "seems"
to work. I have not spent a lot of time with it, but
I have a few question if anyone has a working one ....
first
I am only using 6 outputs, abc and ijk.
at first I had a jumper in place as shown.
output looked like 9.44, 4.53, 4.53, 4.53, 4.53, 5.00 ( fixed 9v in
top and 5 in bottom ( mod)).
or something like that. I removed the jumper and get
finer steps all different, which is what I excepted to get.
oh, no chip in the 3rd scocket.
where should the jumper go - I looked careful, but I did
not get it right the first time. any one have a pic they could
provide?
it drove my serge pco and DSG just fine...
I am very impressed with Ken's pcb layout and designs....
thanks Ken. Can I order a pony too....must say they are
magical.
best - Jeff
well I have just completed the cv cluster module and it "seems"
to work. I have not spent a lot of time with it, but
I have a few question if anyone has a working one ....
first
I am only using 6 outputs, abc and ijk.
at first I had a jumper in place as shown.
output looked like 9.44, 4.53, 4.53, 4.53, 4.53, 5.00 ( fixed 9v in
top and 5 in bottom ( mod)).
or something like that. I removed the jumper and get
finer steps all different, which is what I excepted to get.
oh, no chip in the 3rd scocket.
where should the jumper go - I looked careful, but I did
not get it right the first time. any one have a pic they could
provide?
it drove my serge pco and DSG just fine...
I am very impressed with Ken's pcb layout and designs....
thanks Ken. Can I order a pony too....must say they are
magical.
best - Jeff