thanks Ken
I got it. I figure out the jumper, which is
the same as your suggestion. I put a wire on the
resistors, I think now it would be easier to
put a piece in the 3rd chip socket pins ...
anyway it works! I get even voltages between outs.
all with in a hundredth of a volt, good enough for me.
now I got use it .
thanks
JEff
I got it. I figure out the jumper, which is
the same as your suggestion. I put a wire on the
resistors, I think now it would be easier to
put a piece in the 3rd chip socket pins ...
anyway it works! I get even voltages between outs.
all with in a hundredth of a volt, good enough for me.
now I got use it .
thanks
JEff
--- In cgs_synth@yahoogroups.com, sasami@h... wrote:
>
> >first
> >I am only using 6 outputs, abc and ijk.
> >at first I had a jumper in place as shown.
> >output looked like 9.44, 4.53, 4.53, 4.53, 4.53, 5.00 ( fixed 9v
in
> >top and 5 in bottom ( mod)).
> >
> >or something like that. I removed the jumper and get
> >finer steps all different, which is what I excepted to get.
>
> All of the voltages should be the exact same distance apart. The
actual
> voltages will be different, depending on the inputs, but the
distance
> between A and B should equal that between B an C, C and F, F and
I, I and J
> and J and K, assuming you havent linked the S,Y, X or T terminals.
>
> >where should the jumper go - I looked careful, but I did
> >not get it right the first time. any one have a pic they could
> >provide?
>
> Between pin 3 and 12 of the unused chip location.
>
>
> Ken
>
_____________________________________________________________________
__
> Ken Stone sasami@h...
> Modular Synth PCBs for sale
<http://www.blaze.net.au/~sasami/synth/>
> Australian Miniature Horses & Ponies
<http://www.blaze.net.au/~sasami/>