Datacolor User to User Support Group.

>Thankyou both Davids !
>
>It's a pity the program doesn't allow this. I'll just have to
>remember to note the settings I made each time I make a profile in
>future, so I don't have to start from scratch again each time.

I think there's something here that my still not be clear:

You do NOT have to remeasure any patches to rebuild a profile.

All you need to do is run PFP again; go to the Read Patches screen;
select your (already measured) set of measurements; step forward to the
Build Profile screen; adjust your sliders a different way; and click Next
to build a different variation of the profile.

This only takes a few seconds, there is little or no mental pain or
anguish involved...:-)

There would be no additional benefit to you if PFP was able to directly
modify a profile, other than the few seconds it takes you to launch PFP,
click through those screens, adjust a slider and build a differently-flavored
profile.

Best regards,


-- 
David Miller
Senior Software Developer, Digital Color Solutions
ColorVision