Bill, Thank you very much for helping me with this. I would say that it very likely that I have had several devices connected at once. I do have the the iOS Controller app on my iPad and I do have a Droidlavier app on my Samsung phone. Could they have been all connected at the same. Very possibly! I can think of a holiday a few years back when I setup a playlist on my iMac, and then at the dinner table, had my cell phone at my side to adjust the overall volume level from the table. That same night, I could have used my iPad (only because it was right there and my phone was not with me at that point) as my sisters-in-law played the Piano so that I could record them. The dkvBrowser would have likely still be up on my iMac through all of this. Regarding the PRC100, I believe I can use it. (Although I need new batteries for both it and the tablet.) I know that I have gone into every menu item and attempted to adjust levels from that too. I have not had any luck with it. The same goes for the disklavier tablet. Thank you again. Glenn Smutny G.SMUTNY@... > On Oct 27, 2016, at 7:40 PM, Bill Brandom billbrando@... [disklavier] <disklavier@yahoogroups.com> wrote: > > > Glenn, > > Are you still able to use your PRC100? > > Bill > Love God. Love People. Make a difference. > > > On Oct 27, 2016, at 1:29 PM, Glenn Smutny G.SMUTNY@... <mailto:G.SMUTNY@...> [disklavier] <disklavier@yahoogroups.com <mailto:disklavier@yahoogroups.com>> wrote: > > > Hopefully this will get to Bill B. > > I believe I am interested in a full software reset of my Mark IV. > > I would hate to lose all of the music on my hard drive, but I am having problems with Volume levels being appropriate. Supporting back ground accompaniment is so soft that it can hardly be heard over the piano. I believe, but am uncertain that by using Kevin Goroway’s dkvBrowser on my iMac, might have caused this to happen. (No negative comments here about Kevin. His software works great!) I just think that somehow, some minor little nuance of the program, has messed up a setting on my piano. To date, I have been unable to figure it out. > > I am wondering if by completely removing the Mark IV software and replace it 100%, if I would once again have control of the systems volume levels. > > Any suggestions would be helpful. > > Glenn Smutny > G.SMUTNY@COMCAST.net <mailto:G.SMUTNY@...> > > >
Message
Re: [disklavier] Mark IV reset
2016-10-28 by Glenn Smutny
Attachments
- No local attachments were found for this message.