Disklavier

So I have ordered online the linksys wireless-g bridge WET54g version 
3. I configured it with me PC when it was connected to the LAN.

I then plugged it in to the disklavier but I get the error message 
that it does not see the IP address. Not sure how to link the tho to 
get it to work . Any advice?

david


m--- In disklavier@yahoogroups.com, "dcolema2001" <drcolema@...> 
wrote:
>
> I have my Mark IV connected wireless via a Linksys wireless bridge, 
> Model WET54G.  It plugs directly into the Mark IV's ethernet port to 
> make it wireless.  The bridge connects (wirelessly) to a Linksys 
> access point then via CAT5 wire to a NetGear switch.  I have not had 
> any problems with it since I've installed it.  
> 
> Don C.
> 
> --- In disklavier@yahoogroups.com, "Mike Moore" <mmoore@> wrote:
> >
> > The only surefire way I know is the one I used: I run an ethernet 
> cord
> > into the MarkIV from the wireless Airport Express module that I 
> plugged
> > in nearby.   That's obviously only a quasi-wireless connection.   
> Others
> > in this forum may have found some sort of wireless device that 
> plugs in
> > directly to the Mark IV's ethernet or other ports.
> >  
> > Mike M.
> > 
> > ________________________________
> > 
> > From: disklavier@yahoogroups.com 
> [mailto:disklavier@yahoogroups.com] On
> > Behalf Of dcgreenhfx
> > Sent: Tuesday, October 21, 2008 6:33 PM
> > To: disklavier@yahoogroups.com
> > Subject: [disklavier] Internet solution for connecting Disklavier 
> Mark
> > IV
> > 
> > 
> > 
> > Does anyone have surefire way to make a wireless internet 
> connection 
> > for my Mark IV?
> >
>