Dotcomformat

I've added your request to our "to-do" list. Thanks for the suggestion!

Moe
http://www.stoogeindustries.com

--- In dotcomformat@yahoogroups.com, "Larry T." <larry@...> wrote:
>
> I'm hoping one of the Stooges will get this message, as I don't have
> e-mail on this pc...
> 
> Remember the 'Blacet to MOTM' adapter panel that Blacet used to sell?
>  It would fit one double wide or two single wide Frac Rack panels into
> one MOTM panel, and had pilot holes for 8 1/4" jacks at the bottom of
> the panel.  When John discountinued these, I bought all I could aford,
> but I'm about to run out!
> 
> How about a Synth Dot Com 1u panel to mount Frac Rack format 1u panels
> and a Synth Dot Com 2u panel to mount Frack Rack format 2u panels in?
>  They don't need to come with screws and nuts to mount the panels,
> just pilot holes so you could use the same self taping screws as are
> used on the Frac Racks.  In the 1u panel, you can get 4 x 1/4" jacks
> at the bottom, and you could set a mark on the back of the panel for
> the standard Dot Com jack spacing.  That way if you did't need or want
> all 4 jacks, you just drill a small pilot hole from the back, then up
> size the hole from the front for your jack or switch.  In the 2u
> panel, if you offset the Frac Rack panel, I beliece there is room for
> 10 jacks at the bottom and another 6 jacks up the side.  Again, just
> score the locations for the jacks from the back and punch the panel
> mounting hole and mounting screw holes.
> 
> Is this possible?
> 
> Or maybe just make the exact same MOTM mounting panel that John used
> to make (I'm sure you could get permission from him, he stopped making
> them afterall!)
> 
> Best of luck with Stooge Industries!
> 
> Larry T.
>