Emax

Hi thank you but the  l c d  is working fine its just reading disk not formatted when i try to boot the unit up and when i take the disk  out and then try to turn it on again it just shows its looking for the  S C S I  AND THE DISK DRIVE JUST KEEPS ON SPINNING  ?
-----Original Message-----
Date: Tuesday, August 31, 2010 4:21:47 pm
To: <emax@yahoogroups.com>
From: "jammie" <jammie.emma@...>
Subject: Re: [emax] LCD for Emax 1

it is the pc1602-h you will also need a el panel for it

the new screens also dont use negitive feed back for inverted displays so if you are fitting to a rack you have to discard the inverter circuit and fit a pot between pin 3 and ground and vcc

ted has done it recently so he can also give you an idea
  ----- Original Message ----- 
  From: jamesulibarri 
  To: emax@yahoogroups.com 
  Sent: Tuesday, August 31, 2010 11:51 PM
  Subject: [emax] LCD for Emax 1


    
  Hi,

  Where are you guys getting your Emax 1 replacement LCD's
  The more blue the better, but anything will work at this point. 
  Is it a MDK52V-0 or PC1602-H? I am not seeing too much online, but I am sure I am just not seeing it. 

  Thanks



  


------------------------------------------------------------------------------



  No virus found in this incoming message.
  Checked by AVG - www.avg.com 
  Version: 8.5.441 / Virus Database: 271.1.1/3104 - Release Date: 08/31/10 06:34:00


[Non-text portions