Emax

`sounds like either the floppy disk is damaged or the floppy drive is malfunctioning

have you got a scsi drive installed or fitted externally and is it set to 0if not the floppy drive will look for a os disk in the floppy drive 
  ----- Original Message ----- 
  From: roy thomas 
  To: emax@yahoogroups.com 
  Sent: Wednesday, September 01, 2010 4:16 AM
  Subject: Re: [emax] LCD for Emax 1


    
  Hi thank you but the l c d is working fine its just reading disk not formatted when i try to boot the unit up and when i take the disk out and then try to turn it on again it just shows its looking for the S C S I AND THE DISK DRIVE JUST KEEPS ON SPINNING ?
  -----Original Message-----
  Date: Tuesday, August 31, 2010 4:21:47 pm
  To: <emax@yahoogroups.com>
  From: "jammie" <jammie.emma@...>
  Subject: Re: [emax] LCD for Emax 1

  it is the pc1602-h you will also need a el panel for it 

  the new screens also dont use negitive feed back for inverted displays so if you are fitting to a rack you have to discard the inverter circuit and fit a pot between pin 3 and ground and vcc 

  ted has done it recently so he can also give you an idea 
  ----- Original Message ----- 
  From: jamesulibarri 
  To: emax@yahoogroups.com 
  Sent: Tuesday, August 31, 2010 11:51 PM 
  Subject: [emax] LCD for Emax 1 



  Hi, 

  Where are you guys getting your Emax 1 replacement LCD's 
  The more blue the better, but anything will work at this point. 
  Is it a MDK52V-0 or PC1602-H? I am not seeing too much online, but I am sure I am just not seeing it. 

  Thanks 






  ---------------------------------------------------------- 



  No virus found in this incoming message. 
  Checked by AVG - www.avg.com 
  Version: 8.5.441 / Virus Database: 271.1.1/3104 - Release Date: 08/31/10 06:34:00 


  [Non-text portions 



  


------------------------------------------------------------------------------



  No virus found in this incoming message.
  Checked by AVG - www.avg.com 
  Version: 8.5.441 / Virus Database: 271.1.1/3104 - Release Date: 08/31/10 06:34:00


[Non-text portions of this message have been removed]