Emax

solder all pins pin3 is n/c on the lcd pcb fit a 14 pin header 

remove 2 pin header for the el backlight  
  ----- Original Message ----- 
  From: mcnik_k 
  To: emax@yahoogroups.com 
  Sent: Wednesday, December 14, 2011 5:53 PM
  Subject: [emax] Re: oled display


    
  Hey there... I ordered one of these, should be with me tomorrow.

  You say you "left pin 3 disconnected", then you go on to say you "just leave 15-16 disconnected". Can you confirm which pins should not be connected on the new display?

  Also, I know where the inverter is, I take it I just disconnect it and that is it done? Do I have to do this before testing the new display?

  I'm not sure where the backlight connector is though, and what to desolder?

  Thanks!

  --- In emax@yahoogroups.com, "Mark" <freqspec@...> wrote:
  >
  > Im a donut the part no. is WEH001602C (85x36) no the one i mentioned below.
  > I will try and post some pics by the weekend
  > 
  > --- In emax@yahoogroups.com, "Mark" <freqspec@> wrote:
  > >
  > > just in case anyone is interested I purchased a WEH001602A-Y from rapidonline.com
  > > i bought a pin header off ebay and soldered it on to the display plugged it in
  > > and it worked. set me back 25 gbp in total and i didnt have to cut away at anything.
  > > it just fitted straight in as the dimensions are exactly the same.
  > > left pin 3 disconnected and desoldered the old backlight connecter and inverter.
  > > the new display has 16 pins but you just leave 15-16 disconnected.
  > > I hope this helps anyone wanting to upgrade their screen.
  > > Thanks to everyone who supplied info before hand.
  > >
  >



  

[Non-text portions of this message have been removed]