Emax

The Emax I definitely does not monitor sample input. It states this clearly in the manual. Use an fx send bus on your mixer or something else to monitor the signal when sampling.

FYI,
Dave

On Dec 30, 2011, at 13:10, Ted Summers <djtbs1@...> wrote:

> You are putting this through a phono pre-amp first, right?
> because otherwise the turntable signal output (unless it is a newer table
> with a line level out) would be way too low...
> 
> 
> On Fri, Dec 30, 2011 at 11:20 AM, jdchevallier <joel.chevallier@...>wrote:
> 
>> **
>> 
>> 
>> Still trying to get my emax to sample!
>> 
>> I'd been having problems with the machine not getting an input signal (or
>> a very weak one.) Before shipping it off for repair I pulled each of the
>> chips inside, dusted the board and reseated them. Not too technical, but I
>> now have a visible signal when sampling...it seems to have worked.
>> 
>> When sampling I can however only see the signal in the vu mode...I can't
>> heard anything. Should I be able to hear the audio passing from my
>> turntable, through the emax, prior to sampling? I can only hear the signal
>> after I've sampled, which obviously makes picking an exact spot on the
>> record to sample a bit tricky!
>> 
>> Not sure if there is a setting I've disabled, if this is yet another
>> problem with my board, or something else.
>> 
>> Any insight, as always, is appreciated greatly.
>> 
>> Joel
>> 
>> 
>> 
> 
> 
> [Non-text portions of this message have been removed]
> 
> 
> 
> ------------------------------------
> 
> Emax and Emax II User's Group Website
> 
> http://www.silveriafamily.comYahoo! Groups Links
> 
> 
>