Emax

Thank you for the fast answer. Where can I change the jumper?



--- In emax@yahoogroups.com, Ted Summers <djtbs1@...> wrote:
>
> Emax 1 uses SCSI ID 0 for the CF drive.
> Emax 2 uses SCSI ID 1 or higher- did you change the jumper?
> 
> If not- that would be a reason why.
> 
> 
> On Mon, Jun 4, 2012 at 12:50 PM, freddy1771994 <freddy1771994@...>wrote:
> 
> > **
> >
> >
> > Hi,
> >
> > I bought an Emax 1 with cf card reader and slim floppy drive from group
> > member jammie.emma which works fine. But in consideration of the fact that
> > I have 5gb of emaxII (working with zip100 can be annoying then), but only a
> > few hundred mbs of emaxI sounds (the internal ZIP I bought doesn't work
> > eiter - but that's a different sory) I wanted to mount the cf card reader
> > into the emaxII.
> > I did so, but it doesn't work.
> >
> > It's easy to describe:
> >
> > 1) The emaxII simply does not see it or react on it, if the cable is right
> > round on the pcb.
> > 2) I hoped, "ok maybe it's the other way round than I used to have it
> > installed when the harddrive was in." I did it and now all the lights were
> > continously lit. After having it switched on and booting from the floppy
> > the display completely refused any kind of work and it's turns black after
> > the "Loading Software" message.
> >
> > No worries; I didn't mess it up. When I put it into the emax I angain it
> > worked fine.
> >
> > Do you have any ideas where this problem might result from?
> >
> > Thank you very much!!!!
> > Freddy
> >
> >  
> >
> 
> 
> [Non-text portions of this message have been removed]
>