Emax

You probably have one of the two AC not connecting well- that can cause that behavior....

On Jun 13, 2012, at 4:43 PM, llingo_apt wrote:

I actually have a emax 1 ...so those are not needed at all for the new ps on the emax 1 either? i tried pluggin it in and its not working properly..some rapid flashing and hmming, no fuse blown though. 

--- In emax@yahoogroups.com, "jammie" <jammie.emma@...> wrote:
>
> just put the 2 spades together and tape 
> 
> they are not needed as the emax2 psu version was switchmode and auto sensing circuits for 110vac and 220-240vac
> 
> where as the emax version 1 psu had a switching transformer that could put the 110 dual inputs into series to make a 240 circuit via the switch on the back thats what the 2 red wires are for
> 
> they arnt needed and dont have any electrical connection on the new psu
> ----- Original Message ----- 
> From: llingo_apt 
> To: emax@yahoogroups.com 
> Sent: Wednesday, June 13, 2012 11:09 PM
> Subject: [emax] replacing power supply with one purchased from epr
> 
> 
> 
> I cannot find a spot to hook up the voltage selector wires on this new power supply i just purchased from eps...everything is hooked up otherwise in their proper spot but these two wire locations seem to have no home!?
> 
> any help would be greatly appreciated
> 
> thanks
> 
> 
> 
> 
> 
> [Non-text portions of this message have been removed]
>





[Non-text portions of this message have been removed]