Emax

thanks- yeah i dunno...my blue and brown power cables seem to be solid as does my ground and pins...its not working at all....just squealing and lighting a few buttons up dimly...strange..can't figure it out i have a call in to epr we'll see i guess.

--- In emax@yahoogroups.com, Ted Summers <djtbs1@...> wrote:
>
> You probably have one of the two AC not connecting well- that can cause that behavior....
> 
> On Jun 13, 2012, at 4:43 PM, llingo_apt wrote:
> 
> I actually have a emax 1 ...so those are not needed at all for the new ps on the emax 1 either? i tried pluggin it in and its not working properly..some rapid flashing and hmming, no fuse blown though. 
> 
> --- In emax@yahoogroups.com, "jammie" <jammie.emma@> wrote:
> >
> > just put the 2 spades together and tape 
> > 
> > they are not needed as the emax2 psu version was switchmode and auto sensing circuits for 110vac and 220-240vac
> > 
> > where as the emax version 1 psu had a switching transformer that could put the 110 dual inputs into series to make a 240 circuit via the switch on the back thats what the 2 red wires are for
> > 
> > they arnt needed and dont have any electrical connection on the new psu
> > ----- Original Message ----- 
> > From: llingo_apt 
> > To: emax@yahoogroups.com 
> > Sent: Wednesday, June 13, 2012 11:09 PM
> > Subject: [emax] replacing power supply with one purchased from epr
> > 
> > 
> > 
> > I cannot find a spot to hook up the voltage selector wires on this new power supply i just purchased from eps...everything is hooked up otherwise in their proper spot but these two wire locations seem to have no home!?
> > 
> > any help would be greatly appreciated
> > 
> > thanks
> > 
> > 
> > 
> > 
> > 
> > [Non-text portions of this message have been removed]
> >
> 
> 
> 
> 
> 
> [Non-text portions of this message have been removed]
>