Emax

The drive works fine on ID7 loads banks and saves without issue. 
I have changed the jumpers to switch it to ID1 and still get the same problem the Emax is still only looking for the floppy


S.


________________________________
 From: dwv1957 <dwv1957@...>
To: emax@yahoogroups.com 
Sent: Tuesday, 18 December 2012, 18:37
Subject: [emax] Re: Emax II failing to boot from SCSI device
 

  
You cannot use ID7, 7 is the address of the scsi controller, set it to something between 1 and 6 and it should be fine (0 is the floppy)

Dave

--- In emax@yahoogroups.com, Francis Cote  wrote:

I have the same annoying issue. Is this EEPROM replaceable?
On 2012-12-18 12:10 PM, "Simon"  wrote:

**


Hi Guys.. I posted this up a while ago, but am looking for a solution here

The Emax boots from floppy, but when I try to assign it to boot from an
internal SCSI drive (ID7) it says it saves the setting but still searches
for the floppy on bootup.

The settings appear to be saved as it is still set to ID 7 when you go
back into boot ID settings but the Emax still insists on a floppy being
inserted to boot
The Emax should be able to boot from any ID right?..

Is this likely a failing of the EEPROM at IC24?..





[Non-text portions of this message have been removed]


 

[Non-text portions of this message have been removed]