Emax

hi folks ,  i'm still stuck after booting with the bootdisk 6.22
provided in the files section and using a fat16 formatted 1.44 disk to
contain the image and emaxutil ,  i still get the same message error
in emaxutil  : 
can't read /write the  image 
what can i do now  ,since  i wasn't able to load it from a usb key 
and i only have SATA hard drives and only one floppy drive . did 
anyone managed to do it  with a complete virtual dos system ( using
VMware  )
thanks a lot !

Did you make sure you are using a 720K disk to write the image to?  
They are 1.44MB floppy, but emax only reads / writes 720. So it MUST  
have the hole covered (not the write protect, the other one).

Just a thought.
Ted

On Oct 17, 2007, at 12:18 PM, mks50 wrote:

> hi folks , i'm still stuck after booting with the bootdisk 6.22
> provided in the files section and using a fat16 formatted 1.44 disk to
> contain the image and emaxutil , i still get the same message error
> in emaxutil :
> can't read /write the image
> what can i do now ,since i wasn't able to load it from a usb key
> and i only have SATA hard drives and only one floppy drive . did
> anyone managed to do it with a complete virtual dos system ( using
> VMware )
> thanks a lot !
>
>
> 



[Non-text portions of this message have been removed]