EXS 24 Logic Sampler Users Group

00-12-12 00.20, skrev exs-users@egroups.com på exs-users@egroups.com
följande:

> Message: 3
> Date: Mon, 11 Dec 2000 19:29:30 -0000
> From: philter@...
> Subject: Automation Issue
> 
> I had 5 EXS instruments instantiated and I wanted to automate the
> filter cutoff frequency.  I put Logic in record and moved the knob
> with my mouse to record the data.  When I went to play it back, I got
> no action from the EXS.
> 
> When I looked at the Event list everything looked fine except that it
> didn't say anything in the info column (where it normally says
> EXS#xx).
> 
> After further investigation I realized that the Low Cut filter that I
> had plugged in on that track had showed up in the list of Controller
> numbers 'cutting off' the regular EXS parameters.  When I unplugged
> the Low Cut plug, then I saw the full list of the EXS parameters and
> the automation played back fine.
> 
> I was wondering what the logic is with this type of setup.  Can I not
> have any plug-ins on an EXS track that I want to automate?  Is there
> a way to determine what Contollers a plug will use or if it should
> respond to MIDI data at all?
> 
> Just wondering if any of you have run into this and found any
> possible workarounds.
> 
> thanks,
> 
> Philip

Hi Philip,

One workaround would be to set the output of the EXS to a bus and have the
plugins there instead. Now the automation should work aswell as the plugins.

Mardyk