Mailist to discuss all issues regarding the Digitech GSP-2101 Guitar FX Processor

Hi Folks,
   I am new to the group but a long time lover of the GPS2101. I am 
looking for some expertise with a problem.

I have created two programs. One doesn't use the GSP2101FC pedal (call 
this program A) and another program does use it(call this program B). 

Program B is setup to increase the gain on distortion from 3 to 11 
while simultaneously reducing the master volume to maintain a 
consistent output level. My problem is when I switch from program A to 
B.

The pedal is up when I am in program A. I expect to switch to program B 
and have all the parameters for that pedal position maintained at the 
initial reasonable clean setting up to hot when depressing the pedal. 
Unfortunately when I switch to program B the parameters are as if the 
pedal was down (or nearly down) unless I just touch it a bit. IT is 
almost like it is not reading the initial pedal position when I switch 
to B until a touch the pedal.

Any thoughts? Thanks Experts and have a great day! :)

Best Regards,
 Dan