dpguitarman wrote:
Hi Folks,
I am new to the group but a long time lover of the GPS2101. I am
looking for some expertise with a problem.
I have created two programs. One doesn't use the GSP2101FC pedal (call
this program A) and another program does use it(call this program B).
Program B is setup to increase the gain on distortion from 3 to 11
while simultaneously reducing the master volume to maintain a
consistent output level. My problem is when I switch from program A to
B.
The pedal is up when I am in program A. I expect to switch to program B
and have all the parameters for that pedal position maintained at the
initial reasonable clean setting up to hot when depressing the pedal.
Unfortunately when I switch to program B the parameters are as if the
pedal was down (or nearly down) unless I just touch it a bit. IT is
almost like it is not reading the initial pedal position when I switch
to B until a touch the pedal.
Any thoughts? Thanks Experts and have a great day! :)
Best Regards,
Dan
Luggage? GPS? Comic books?
Check out fitting gifts for grads at Yahoo! Search.