Hello all, I just bought a 2101 off Ebay and received it yesterday. The packing job wasn't the best but adequate I assume. Forgive me if am asking a retorical question here but I have searched all 428 messages looking for an answer to my issue before I posted.....So here goes. It is circa '95 that has been upgraded to Artist 3.00 a software, single PPC. When I turn it on it goes through the startup procedure and then sometimes loads to program 1, other times P80 (flashes), 240 and so on. If it does happen to laod to program 1 as soon as I grab the dial and turn it to ascend to 2,3 and so on it does this computer code thing, says "I need a PPC" on P3 and then proceeds to reboot? If I do a factory reset all is well until I change parameters on any program then as soon as I shut it off and turn back on again the same routine starts all over again. This is actually my second 2101, I stupidly sold off my first one for a POD Pro....Yea I know what the hell was I thinking!!! If any if you folks could offer some advice as to where to proceed from here I would greatly appreciate it. I haven't let the seller know as of yet because I wanted advice first and then I would proceed with either him or UPS for damage to the unit.... Thanks in advance, Sincerely, Kevin Schertell You can reach me at the following: telecasterkid@... kevin.schertell@...
Message
My New 2101
2004-04-16 by telecasterkid