Mailist to discuss all issues regarding the Digitech GSP-2101 Guitar FX Processor

I have a Control One where several of the light touch switches are 
starting to fail.  I've purchased some new ones and they should be here 
next week.  I've opened up the Control One and it appears that I can 
replace these switches without having to remove the PCB.  Is this 
correct?

The new switches should be four contact snap dome or similar type. You will need to soulder from one side and remove from the other. So if you can do that with out removing the PCB your GOOD. :-)  It is easy. 

----- Original Message ----
From: dunkin_donut3 <dunkin_donut3@...>
To: gsp-2101@yahoogroups.com
Sent: Friday, December 29, 2006 3:56:38 PM
Subject: [gsp-2101] Control One switch replacement









  


    
            I have a Control One where several of the light touch switches are 

starting to fail.  I've purchased some new ones and they should be here 

next week.  I've opened up the Control One and it appears that I can 

replace these switches without having to remove the PCB.  Is this 

correct?





    
  

    
    




<!--

Thanks,

I was sure I could figure it out but just wanted to make sure I wasn't 
missing something obvious.  I think holding the switch with a 
needlenose and desoldering shouldn't be a problem.