The Logic Off Topic list

logic-ot@yahoogroups.com wrote:

> Original Message:
>    Date: Wed, 15 May 2002 20:24:41 +0100 (BST)
>    From: alan platten <taoyoyo@...>
> Subject: yamaha o1v dat board to m-audio delta 1010/ai
>
> hi everyone...
>
> the my8-at a-dat board i had on order finally arrived
> today but i'm having trouble getting it to link up
> with my m-audio delta 1010/ai.
>
> the my board seems to be working okay on the o1v...
> select the main l/r mix and the output page registers
> the levels but the m-audio won't input them.
>
> on the other side the 1010 seems to be hooked up fine
> to the main 1010 unit... switch the 'adat to host' on
> and the signal (dat) coming into the analog ins is
> cancelled (as the manual says).
>
> i've checked the two optical cables on a yamaha a5000
> sampler into the inputs of a roland vm-3100 mixer...
> the signal gets through to that okay so it's not the
> cables and i'm sure i got everything else connected
> correctly but... no signal gets either from the o1v to
> the ai or vice-versa.
>
> has anybody got had experiences with this set-up that
> might have some suggestions? would be hugely
> appreciated! :) the delta mixer/monitor box locks onto
> 'wordclock' when 'adat to host' is on too!

Hi Alan,
Your question may be better served in the O1v group (O1v@yahoogroups.com).  I
know several people there may be using the same rig, or at least using the ADAT
card successfully, for sure.  And, there are some very knowledgeable people on
that list, as well.  I'll cc this to over there and you can just join up and
look for your answer.  :)

Regards,
...z


"Problems cannot be solved at the same level of awareness that created them."
-Albert Einstein

-- Zeek Duff's-CDs-OMNIVORE-(Parts 1 & 2)-
*NEW*-SpringTime-*-Zeek Duff Omnivore Collection-*
http://artists.mp3s.com/Zeek_Duff
or preferred for downloads
http://www.ampcast.com/ZeekDuff