MOTM

I use this exact same technique.

Moe

--- In motm@egroups.com, "J. Larry Hendry" <jlarryh@i...> wrote:
> You know, this brings up a good point.  I know everyone has their 
own ways
> of checking their work.  But, I have found that trying to go back 
and check
> a lot of joints after-the-fact is hard to tell where you are going 
and where
> you have been.  So, I will share something that works for me.  I 
check all
> of my joints under magnification before I trim the leads.  Then 
when I am
> happy, I trim the leads off.  So, after soldering a few parts on, I 
stop,
> inspect and clip.  Everything not clipped needs to be inspected.