OBERHEIM SYNTH

Or try to make a ctrlr panel for it?Ctrlr - Control your MIDI life (MIDI editor for all your hardware)
|   |
|   |   |   |   |   |
| Ctrlr - Control your MIDI life (MIDI editor for all your hardware)Cross Platform Works on Windows (XP and up, both 64 and 32bit binaries are available), MAC OSX (10.5 and up), Linux (any modern distro should run it). Host in your DAW  |
|  |
| View on ctrlr.org | Preview by Yahoo |
|  |
|   |

 

     On Tuesday, 18 November 2014, 15:32, "Marcelo Malmierca estudiosgong@... [oberheim]" <oberheim@yahoogroups.com> wrote:
   

     [Attachment(s) from Marcelo Malmierca included below] Buy a hardware controller !

Marcelo Malmierca
On 18/11/2014, at 11:48, "'Nicole Massey' nyyki@... [oberheim]" <oberheim@yahoogroups.com> wrote:

    Do we have a chart somewhere as to what NRPN parameters are controlled by particular messages? (I'm only recently back here)
You can find a good discussion of how this works at the following link. I've built some RPN parameters to control pitch bend range, but I haven't dealt with NRPN stuff, though the sequencing of the messages should be similar.
http://www.2writers.com/eddie/TutNrpn.htm

> -----Original Message-----
> From: oberheim@yahoogroups.com [mailto:oberheim@yahoogroups.com]
> Sent: Tuesday, November 18, 2014 8:32 AM
> To: oberheim@yahoogroups.com
> Subject: Re: [oberheim] Re: Matrix-1000 Firmware 1.14
> 
> 
> 
> I recently tested the V1.14 rev and was able to control the parameters
> using NRPN messages. I then put V1.13 back into my M-1000 and it
> ignored the messages. I haven't done a long term test or tested every
> value for every parameter but the fix works as advertised.
> 
> 
> It was quite a brain workout using Midi-Ox mapping with my Novation
> Remote LE. I'm still not sure exactly how to setup the MSB, LSB, and
> data CC's. It probably would have been easier to write a script. Does
> anyone have do this kind of real time editing all the time and could
> possibly offer some pointers or an online resource?
> 
> 
> On Tuesday, November 18, 2014 9:08 AM, "sebo@...
> [oberheim]" <oberheim@yahoogroups.com> wrote:
> 
> 
> 
> 
> 
> No, I just implemented the bugfixes, not the mods. For the mods
> you need the new CPU and clock.
> 
> 
> 
>