Xpantastic!

:-)))




________________________________
From: "endofcommon@..." <endofcommon@...>
To: xpantastic@yahoogroups.com
Sent: Mon, March 11, 2013 6:30:59 PM
Subject: Re: [xpantastic] I got it now was/Xpander Midi Recieve Channel

  
Ok, I got it now Karl, how frustrating all these steps!  : ) 

The key here is the Zone button under Master page that you mention which was set 
to Omni for all 3 zones.
Changing this to the desired channel worked and everything is good now.  I was 
confusing the CV/Midi and Zone as one button not two.

Appreciate the help! e


On Mar 11, 2013, at 7:04 PM, Karl Schmeer wrote:

  
>Hi,
>Each zone (in single mode) may be set to it's own midi channel, 
>or to Omni mode. 
>
>Try this button sequence:
>
>>> Master Page >>  Zone >> Zone Number (1 - 6)
>
>At the far right of the zone page is the midi channel, make sure it is 
>not set to omni.
>
>Best Luck
>
>Karl
>
> 
>
>________________________________
>From: "endofcommon@...@...>
>To: xpantastic@yahoogroups.com
>Sent: Mon, March 11, 2013 5:31:12 PM
>Subject: Re: [xpantastic] Xpander Midi Recieve Channel
>
>  
>Xpander Master Midi channel is set to Ch1 (Master, Midi, Channel), Logic is 
>sending out on Ch. 1  (tested all other channels working correctly). Has it to 
>do with midi zones/ (master/midi/zones) perhaps ? Again this is in single mode. 

> Thanks, e 
>
>On Mar 11, 2013, at 6:17 PM, Ancient Eyeball Recipe wrote:
>
>  
>>
>>
>>Well, my guess would be that either the xpander doesn't have its midi channel 
>>set to one (I think that the default may be 'omni', which would produce your 
>>symptoms), OR you're channelizing the output incorrectly  through your DAW, 
>>which can be easy to do. 
>>
>>
>>
>>In any case, I'm not in front of my matrix 12 at the moment, but logically 
>>that's what comes to mind.
>>
>>________________________________
>From: endofcommon@...
>>To: xpantastic@yahoogroups.com
>>Sent: Monday, March 11, 2013 3:24:05 PM
>>Subject: [xpantastic] Xpander Midi Recieve Channel
>>
>>  
>>Until recently I had my my Xpander on its own midi buss, but due to 
>>some setup thinning out, it now needs to share a midi bus (1 Midi out 
>>from a Emagic MT-4) with other synths but I cannot seem to set it 
>>correctly in single mode to receive on just one midi channel, it wants 
>>to respond to all channels, could someone please go over these steps 
>>with me please, I must be missing something. Thank you, e
>>
>>OB Xpander
>>Processor v1.2
>>Voice v1.4
>>Casette v1.0
>>
>>
>>
>
>