Yamaha CS80 group photo

Yahoo Groups archive

Yamaha CS80

Index last updated: 2026-04-28 23:44 UTC

Message

Re: What's the best way to test for a bad IG00152 EG-VCF on an M-Board?

2010-06-18 by Quazimodo

That's the filter envelope chip. I had one go a while back, go to panel, set your resonance and filter so the envelope has max effect and play with the filter ADR settings. On mine the filter was always closed no matter the ADR was set to.

Cheers,
TOM




--- In yamahacs80@yahoogroups.com, "mborish_2000" <mborish_2000@...> wrote:
>
> I think that mine is bad on CHII Voice 8.  It ramps up, sustains at full blast until I let go of the Key, then ramps down.... I think.  It's really hard to tell.  
> 
> If I remember correctly, I am getting 4V DC at at TP1 - I can check again later today.
> 
> Trig is functioning normally and voice I is functioning normally.
>

Attachments

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.