200e

thanks guys -- so the plug is the long green piece the wires attach  
too, and can be un-plugged easily/safely? Then plugged back into the  
buss at new position (I plan to move module to a different boat,  
otherwise the wires might just be long enough to leave plugged in )?

So can the plug be plugged in to any available spot on the buss?

Is this procedure something I can screw up and damage any of the  
modules? I don't have much experience with electronics so all tips and  
suggestions welcome.

thanks (and ps, to paint the overall picture -- I wanted to move the  
281e and 292e up to top row left, then move the 291e down from top row  
to middle row left, and, finally, shift the 250 left one space so it  
is situated dead center.)

dimitrios


On 4-Jun-08, at 8:05 AM, Chris Muir wrote:

>
> On Jun 4, 2008, at 3:33 AM, cellabbee wrote:
>
> > What next? DIsattach those wires and re-attach to new position? Or
> > does the whole unit
> > unplug? Anyone know??
>
> I'm guessing that the module you unscrewed was at the right side of
> your case. Am I right?
>
> Those wires are terminated in a plug, which plugs into a "buss board"
> on the back of the cabinet. The buss board doesn't quite run the whole
> width of the cabinet, so the plug may be plugged in under the module
> to the left of the one you removed.
>
> -C
>
> Chris Muir
> cbm@well.com	
> http://www.xfade.com
>
>
> 



[Non-text portions of this message have been removed]