68300

Jochen,

I can send you a pre-programmed GAL if you like. Or even a design for 
a BDM P&E Micro design single layer print that I designed with Eagle.
I don't have any prints left to send you.

Avi.

--- In 68300@yahoogroups.com, "jochen_stroebel" 
<jochen_stroebel@y...> wrote:
> Hi, 
> thanks for your answer
> 
> --- In 68300@yahoogroups.com, "Aaron J. Grier" <aaron@f...> wrote:
> > On Mon, Sep 12, 2005 at 12:01:32PM -0000, jochen_stroebel wrote:
> > > But Codewarrior only supplys the P&E Micro CPU32 BDM Interface 
(or 
> the
> > > P&E Lightning card) now a need a Schematic of the P&E Interface 
or 
> at
> > > least a Pin Out for Parallel-Port, which Signal comes out to 
which
> > > Parallel Port Register (BDM-PD Interface uses Control and Status
> > > Register) (P&E uses Data, Control and Status Register of LPT1 I
> > > Suppose..)
> > 
> > p&e still sells BDM interfaces for CPU32 processors.
> > http://www.pemicro.com/ .
> 
> Yes, but for a Student ist a little expensive, if you see the 
little 
> logic function the GAL has to do, perhaps someone has at least the 
> pinout with the signals on the Parallel-Port-Side of the P&E Micro 
> Interface for CPU32, so i can adapt my homemade PD-BDM-Interface on 
> Parallelportcable?  (I am not complete shure the Motorola IDC 
> compatible BDM cable ist complete equal (on parallel port side) to 
the 
> P&E ?!? )
>  
> > there is also a reverse-engineered schematic and source code for 
a GAL
> > to build a P&E compatible BDM interface at
> > http://sourceforge.net/projects/bdm/ .
> Yes, I see but there is only the discription Motorola IDC 
compatible 
> BDM cable, does it work with Codewarrior for 68k and my QUICC Board 
> from Motorola?
> 
> > -- 
> >   Aaron J. Grier  |   Frye Electronics, Tigard, OR   |  aaron@f...
> 
> One more question, ist the Wiggler IDC compatible, too?