Thanks Micah,
Actually, I had it in my head backwards then. When I read about the
Xtal being problimatic dur to distance, I thought they meant the
internal one which is what led me to think I should install the one
I planned on using.
OKay, I will use the "standard" configuration to get going then.
Thanks
Chris
--- In AVR-Chat@yahoogroups.com, Micah Stevens <micah@...> wrote:
>
>
> It depends on what you want to do, but using your own xtal
directly is
> problematic due to the long transmission lines on that board. What
I would
> suggest is using the board's clock circuitry. Here's how I have it
set up:
>
> xtal jump on.
> OSC jumper on the left two pins (if you can read the silkscreen)
>
> There's a cheatsheet silkscreened on the bottom of the board for
reference..
>
> -Micah
>
> On Friday 03 February 2006 4:34 am, lcdpublishing wrote:
> > Last night I was going over the documentation for the ATSTK500
board.
> > As this thing seems to be the swiss army knife of programmers,
it also
> > comes with a lot of jumpers and cables.
> >
> > I see that you can use either the clock signals from the board,
OR you
> > can put your own crystal on the board. However, when I read
through
> > those directions, I could not make heads or tails of where to
place
> > the two related jumpers.
> >
> > The jumpers I am referring to are XTAL1 and OSCSEL
> >
> > Thanks
> >
> > Chris
> >
> >
> >
> >
> >
> >
> >
> >
> >
> > YAHOO! GROUPS LINKS
> >
> >
> > Visit your group "AVR-Chat" on the web.
> >
> > To unsubscribe from this group, send an email to:
> > AVR-Chat-unsubscribe@yahoogroups.com
> >
> > Your use of Yahoo! Groups is subject to the Yahoo! Terms of
Service.
>