Bc2000 (for the BCF2000 & BCR2000)

Yes you do.
You have to change from the edited preset and back after you have sent it.


--- In bc2000@yahoogroups.com, Jeff B <jeffbee42@...> wrote:
>
> Hello, in addition to the editing knob value issue I just sent, the
other main problem I'm running into is editing a preset (for a BCR)
within BCMan.  My BCR2000 is version 1.10, I'm running WindowsXP SP3,
and the USB driver is the modified 1.2.1.3 that's in the group's file
section.  Here's what I'm doing:
> 
> 1. Within BCMan 1.5.1 I have a Presets window open.
> 2. I'll then click on the 'Show Encoders' button.
> 3. Within the encoders edit window that comes up I'll edit an encoder.
> 4. Close the encoders window.
> 5. Back at the Presets window, with the edited preset selected, I
select menu  MIDI > Send.
> 6. On BCR, it receives the preset, but when finished the lights on
every encoder and button goes off.
> 7. When I send the preset again, while the sysex is being sent the
lights on the encoders go back on, but as soon as the sysex is
finished sending, all of the lights turn off again.
> 
> 
> I've been playing around with this a bit and I've found that if
after sending the preset, if I select the preset right button on my
BCR2000, then the preset left button (to switch to another preset and
then back to the original), the lights on the encoders light up
correctly, and with the correct values.
> 
> So what's going on? I sure hope I don't have to do this every time I
edit a preset as this is a pain.
> 
> 
> Thanks,
> 
> 
> Jeff
>