Re: [xpantastic] How do you pan your Xpander voices
2013-12-20 by endofcommon@...
Would be nice if you could fine detune in the Multi tune page don t you think ?
Yahoo Groups archive
Messages
Page 6 of 32 · 1589 messages matched
2013-12-20 by endofcommon@...
Would be nice if you could fine detune in the Multi tune page don t you think ?
2013-12-20 by Omar Torres
also keep in mind that your voice pan settings also effects what type of sound you are using the Xpander for and how it will play into your mix. (eg...synth
2013-12-20 by endofcommon@...
does seem key to have 1 or 2 middle voices in there and does not seem to mess up the beautiful stereo spread as all. I have experimented with L1, L2, R1, R2 a
2013-12-20 by Omar Torres
I ve always tried to get an even spread. with one or two voices sitting center and the rest gradually going L or R. you want at least one voice center so that
2013-12-20 by endofcommon@...
Always been a L-R-L-R-L-R guy, but have been play around with L2, R2, L2, R2, L2, R2, and L-M-R-L-M-R of late and just curious what others are doing for the
2013-12-16 by endofcommon@...
Thanks for your help, The Xpander is so good in single mode, sometimes we forget how powerful it can be in Multi mode.
2013-12-15 by Omar Torres
2013-12-15 by endofcommon@...
Figured it out. To emulate the 4 voice programmer you also want to set each Zone Mode to Rotate. Make sure each zone is on the same channel in MIDI/CV.
2013-12-15 by Omar Torres
then just follow the same steps I provided, but instead use multi-mode and select a different patch for each of the first 4 voices. -o
2013-12-15 by endofcommon@...
Not quite, The 4 Voice rotates through the 4 SEMS in Rotate mode on its programmer, one vice at time, and you can have different or slight different patches on
2013-12-15 by Omar Torres
turn off two of the six voices in the master page and set your zones to rotate . -o
2013-12-15 by endofcommon@...
Is there and what is the best way to simulate the Oberheim 4 Voice Rotate mode, where each key press goes to a different SEM Module (and theoretically, sound)
2013-12-03 by Jeremy Smith
https://soundcloud.com/outtamongolia/ Called Don t Be So Sad . Filenames are: 30 Vocal 30 Instrumental Cheers, Jeremy.
2013-11-10 by robert hall
thanks for your valuable info-i was wondering why the old caps had to go too. anyways i might have specs on the new encoders soon. thanks again -best wishes On
2013-11-10 by Karl Schmeer
Sounds like a switch bounce issue. Without specs on the new encoders I can only guess. I am curious as to why the de-bounce caps have to be changed out? You
2013-11-10 by <rbhall7ice@...>
hey does anyone know why the new encoders i had put in would settle (click) on even or odd numbers? you can see the in-between numbers as you turn them but
2013-09-26 by PeWe
What a story ! I work w/ an Xpander as 1st owner since I buyed it new in 1987 replacing my OB-8 then. Never had probs working in studios or touring
2013-09-26 by Jeremy Smith
Hi folks, A few years ago, I bought my Xpander from America and imported it to the UK. I noticed soon after buying it that the synth sounds better in 120v
2013-09-08 by Jeremy Smith
Sorry everyone. I ll explain what my post is about. I was worrying that my Xpander wasn t working properly. This video:
2013-09-08 by Jeremy Smith
URL was incorrect. http://www.sanfransys.com/homepages/xpander_comparison/xpandercomparison_lowphase.wav Jeremy.
2013-09-08 by Jeremy Smith
Download this: https://www.dropbox.com/s/v0h7nmszehj0h5e/M12Patches07-13-2012.zip Unzip LowPhase Load it in with Xplorer - File - Open menu Play it. Mine
2013-09-08 by Akva
Hello, Robert Logozar did very good job with my MKS70 a few years ago. I did then ask, if he would also be able to repair Xpanders. And, the answer was
2013-09-08 by robert hall
http://www.rlmusic.co.uk/rlm3/restoration/ best wishes- kent is amazing ________________________________ From: Jeremy Smith To:
2013-09-07 by Jeremy Smith
Hi, I want to service my Xpander, then maybe sell it. Google shows no repair shops. Does anyone have the URL of a servicing/repair shop for the Xpander?
2013-08-26 by Nick Zampiello
i believe you could do something similar to what people do with tx81z s that hum. something about a little hot glue or silicone on the part that vibrates to
2013-08-26 by Omar
this is normal. most if not all Xpanders have the buzz. someone else here may know of a way to make it quieter.
2013-08-26 by endofcommon@...
My friends Xpander has a slightly buzzing transformer (mechanical not audio) and was wondering what some of the tip might be to try and alleviate this ?
2013-08-25 by Jeremy Smith
Hi All done with an Xpander, even the snare. https://soundcloud.com/outtamongolia/relaxed I m Straight Outta Mongolia. I ve been making music since 1998. I got
2013-08-23 by Jeremy Smith
... Thanks for the response! It was helpful. I answer my own question after some Googling: Q:When you DJ, whatÆs your preferred set up as far as software and
2013-08-22 by neil loughran
Good question. I think Thor is fantastic and the modulation possibilities actually exceed the Xpander in some ways... i.e. use of Matrix sequencers, tons of
2013-08-22 by Jeremy Smith
Hi folks, I ve been listening to Futurecop recently. I hear they use Reason, and they use it very well. So how does Reason compare with the hardware Xpander?
2013-08-22 by PeWe
No ! You have to assign a pedal to MIDI controller 64 and then program each patch, the pedal modulating an amp-envelope parameter, sustain level or release
2013-08-22 by endofcommon@...
Is there a way to set a sustain pedal from a master midi keyboard globally to work on all patches on the Xpander ? Cheers.
2013-08-17 by Nick Zampiello
God, loving the expander. it s deep and in your face. smooth but messy? strange/awesome z NEW ALLIANCE EAST!!!! ... New Alliance East - Mastering New
2013-08-17 by finni604
yes. Thanks. I m sorted!
2013-08-17 by Karl Schmeer
go to Master Page Pick the Zone your voices are assigned to (1 - 6) probobly 1 On the zone page at the far right are the key mode settings. Hope this
2013-08-17 by finni604
quite possibly...sounds like it. been a while since i turned her on. where in the menu can I change this?
2013-08-17 by Tony Cappellini
Are you in Unison mode?
2013-08-17 by finni604
Can t seem to figure out why multiple voices are not heard simultaneously. Only one key (note) seems to be playing at any given time. Any ideas?
2013-08-07 by Teemu Tares
Thank you Doug! I ll check this. Tiitu :) To: xpantastic@yahoogroups.com From: cappy2112@gmail.com Date: Mon, 5 Aug 2013 18:34:14 -0700 Subject: Re:
2013-08-06 by Tony Cappellini
The keywords in the subject - iPad Apps
2013-08-06 by synthparts
There s this if you have a PC - http://xplorer.programmer.free.fr/ Doug synthparts.com
2013-08-01 by randycason102@yahoo.com
Couldnt agree more. One of my fav things about my M12 is the UI, it s totally part of the experience for me. Sent from my Verizon Wireless Phone ... From:
2013-08-01 by envia94
I agree, but software could be used to visualize most of the settings at once or change several of them quickly by using a graphical patch map similarly to
2013-07-31 by Omar
IMHO, remote control and/or software editing goes against the experience . Short of navigating complex modulation routings, the Xpander has a very well
2013-07-31 by Karl Schmeer
Last time I checked there are lots of DIY remote controller apps out there. I think the complexity of the Xpander, having to use sysex commands and the
2013-07-31 by envia94
Hi, After the discontinued iXpander iPad App, does anybody know if there are any better Midi App suitable for controlling Xpander available or planned? (PS. I
2013-05-24 by mattvrazo
... Having done some more testing, I can address my own comment a bit better. This may not be news to some people, but distortion is definitely present with
2013-05-24 by mattvrazo
Hi all, This has been discussed before, and I have since been in contact with the person who did this (Keith Sterling) to their Matrix-12, so I wanted to share
2013-04-21 by PeWe
Moog Subfatty and Minitaur are V/Hz OSCs which allows steady OSC frequency beating across the OSC´s range. You can come somewhat close using the Xpander´s