Yahoo Groups archive
Messages
Page 248 of 274 · 13692 messages matched
2002-02-18 by clare@excelsiordirect.com
Hi Kathy, I have to agree with Robert about the size - we have just taken delivery of a 6ft1 disklavier - DC3A, and we think its just right - we certainly
2002-02-18 by robert_swirsky
I ve only used the CD on my C-7 Mark III a couple of times, to play with the demo disk that came with it, and later to try a QRS disk to see if it worked. I
2002-02-18 by Kathy Sharp
I m seriously shopping for a disklavier and have found a couple older ones on the secondary market. They do not have the CD technology. I ve been leaning
2002-02-18 by Jack.Schueler@sybase.com
I have bought this way but then I m a Canadian. The only concern I d have if I was a US citizen, is about obtaining service in the US for a model purchased in
2002-02-18 by Kathy Sharp
jb- I ve been checking into a disklavier and spoke with a dealer in Ontario last week. He said the price is the same as stateside except the exchange rate is
2002-02-18 by jpbtacj
I m interested in buying a Yamaha piano (model not yet determined). I ve seen that the Canadian prices w/shipping are significantly lower than in the US. Has
2002-02-12 by Todd Muncy
Ten weeks ago I reported that we were up to 550 members after two years of existence. The number of applications to join have been pouring in since then,
2002-02-12 by Todd Muncy
John Benenati sent me a question about Digital GranTouch models, so I thought my comments might be of interest to the whole group. My answer is followed by
2002-02-08 by fakepopster
Does anyone have an idea where I might get one? Thanks
2002-02-07 by fakepopster
Thanks for the input. Yes, the piano does play softly if I turn it down, although it may miss a soft note if turned to the lowest level. Perhaps I do have a
2002-02-06 by PianoBench@aol.com
Good morning, everyone. In a message dated 2/2/02 3:21:55 PM, Bob writes:
2002-02-06 by PianoBench@aol.com
Good morning, everyone, In a message dated 2/1/02 6:27:41 PM, raydene@netzero.net writes:
2002-02-06 by PianoBench@aol.com
Hello Everyone, In a message dated 2/1/02 4:07:58 PM, Ken writes:
2002-02-04 by James Patrick Sinclair
do you think this will interface w/ a mx-100a, a dsr-1, & that free-standing cd player that permits playing of pianosoft plus audio titles? it seems it is
2002-02-04 by Carol Beigel
Yes, you can ruin an upright piano action by the solenoids playing the piano too loudly. That is the problem playing MIDI files created with an electronic
2002-02-04 by Thomas N. Wheeler
My dealer just returned from a trade show where Yamaha announced a very interesting new technology called PianoSmart. As I understand PianoSmart it is
2002-02-03 by midi_magic2000
If this disk is the same as most Yamaha s disk then it is missing the Boot sector. Which is why your PC cannot read it. As you now have a copy you could try
2002-02-02 by bnbwv
Greetings DKV fans: Ahhh! My favorite subject. Loudness/Velocity. I have an older 92 model wagon grand, and one of my original problems was that it played
2002-02-02 by fakepopster
I m using the free version of Anvil Studio to do this. http://www.anvilstudio.com/ ... work.
2002-02-02 by Robert E. Welcyng
Len, You might consider PG Music s Power Tracks at $29. See http://www.pgmusic.com/powertracks.htm Bob ... -- Robert Welcyng Anchorage, Alaska
2002-02-02 by cdstacker2000
Hi, I have downloaded some midi files with piano on the wrong tracks. I am looking for a shareware sequencer so I can move these to 1 & 2. The gnmidi program
2002-02-02 by Robert E. Welcyng
I ve experimented in the past (on my DC3 Mark II) to determine the DKV volume setting that reproduces the same sound level as that of the original recorded
2002-02-01 by fakepopster
I have seen several posts on this topic including what velocity should be set to but let me ask this. I have a MX100A. When I play a disk (one I create or a
2002-02-01 by Robert E. Welcyng
Ken, here is the way I ve done it. I have an inexpensive laptop with a CD drive and a Midi Sport MIDI interface. I have Cakewalk installed, although the much
2002-02-01 by kenit.sold
Hi all Just a quick question. My piano dealer has located a DCD1 CD player which will connect directly to my IIXG tone generator. A major reason for
2002-02-01 by mcgregor2play
I have had exactly the same experience with my sample disk which is a 1.44MB diskette. I have only been able to make a duplicate of the sample disk - never
2002-01-31 by crayton1999
Todd & Mike, Yes, it is indeed the 1.44 2HD diskettes that I was asking about. This diskette is the sampler that came with my Disklavier and has both piano
2002-01-30 by Todd Muncy
David Mike has given you exactly the advice I was about to give you. There is one thing I noticed that does trouble me. You said (2HD), by which I think you
2002-01-30 by mcgregor2play
... run ... David, Assuming you are familiar with the dkvutils software available at this site, I would think that the easiest way to allow play on a PC is to
2002-01-29 by crayton1999
Is there a utility that enables Pianosoft Plus (2HD) floppies to run a PC sound card? Thanks in advance. Best regards......David Grubb
2002-01-28 by David Billman
Bill it worked! thanks dave b It sounds like the Mark III has been fooled into thinking its a different model ... Turn power off. Hold L-R buttons while
2002-01-28 by BILL J. BARBER
It sounds like the Mark III has been fooled into thinking its a different model ... Turn power off. Hold L-R buttons while turning power on Press +/YES
2002-01-28 by BILL J. BARBER
The tempo of a piece can be altered as follows: NOTE: If the piece was recorded with METRONOME on you will see beats-measures;if not, you will see
2002-01-26 by David Billman
Newbie with i hope simple problem: new mark 3 worked fine till my son pushed all the buttons... now it plays the right hand too high by several octives, and
2002-01-25 by john5000_71055
Thanks!!! That ought to do it. ... from ... improve ... but I ... in order to ... tempo ... Disklavier ... result in ... performance reason ... trick on ... do
2002-01-25 by mainer_ayah
Soory about the last message, I was in the wrong group. Please disregard. DTN
2002-01-25 by mainer_ayah
Soory about the last message, I was in the wrong group. Please disregard. DTN
2002-01-25 by mainer_ayah
I am considering the purchase of a CVP 207 from Germany. I was wondering if anyone knows if the video format mode (NTSC,PAL) for the video out was selectible,
2002-01-25 by PianoBench@aol.com
Good morning, everyone. In a message dated 1/24/02 11:47:26 AM, John writes:
2002-01-25 by midi_magic2000
I thought they were a better then the norm that would explain why. Midi Magic ... Jazz ... purchased this ... Gunter ... notes. The ... length of ... out a
2002-01-25 by midi_magic2000
Hi I have looked at your converted file. The very first note is on channel 1 which is why it plays. But the rest are still on channel 3 Does your program have
2002-01-24 by Jack.Schueler@sybase.com
Well, I see you found the site with pirated copies of PG Music s Jazz Pianist series (a title which PG Music no longer sell). I purchased this title a long
2002-01-24 by Spencer Chase
The veloset utility is included but it was not written by Richard.It was written by a friend of his, whose name escapes me at the moment. Veloset works on one
2002-01-24 by midi_magic2000
It can be done but you will need to hack the file. If it s a midi file then change the tempo in something like Cakewalk. I think the DVK works on a percentage
2002-01-24 by fakepopster
Your files worked terrific! I wonder what you did that I didn t do. Perhaps it s the tool I m using? ..or just my inexperience. I used Anvil Studio to
2002-01-24 by Todd Muncy
Richard s veloset is also part of the dkvutils suite of programs that is in the Files section of our site. ... From: Spencer Chase To:
2002-01-24 by john5000_71055
I have a new DC3A. When I try to slow the tempo on music played from a floppy disk, it will slow only to 50%. For very fast pieces this may be still too fast
2002-01-23 by midi_magic2000
Hi Ray I have downloaded the fist two files from that site. Both files have the piano on track 3 Channel 3 I used Music Studio 3 and rechanneled channel 3 to
2002-01-23 by fakepopster
Thanks for both replies. I do understand that the channel needs to be set to 1 or 2. I should have said channel instead of track. The original files are here:
2002-01-23 by Jack.Schueler@sybase.com
This may simply be your use of terminology but here goes (tracks vs channels). In type 1 SMF files, tracks are used to manage notes for a particular